Hi Guys, i've just setup my Tevo Tornado with Marlin 2.0.x bugfix, UBL enabled.
i did my mesh G29 P1 , then P3 until full, then saved, activated ETC.
but when i do a G26 , the head move a bit then do smal circle on the same spot over and over, no XYZ movement just E, so i get a nice puddle of filament !!!
any idea why?
i do have a A20M under Marlin 2.0.x with ubl working perfectely, i did compare the configs files and cannot pinpoint the problem !!!
i did my mesh G29 P1 , then P3 until full, then saved, activated ETC.
but when i do a G26 , the head move a bit then do smal circle on the same spot over and over, no XYZ movement just E, so i get a nice puddle of filament !!!
any idea why?
i do have a A20M under Marlin 2.0.x with ubl working perfectely, i did compare the configs files and cannot pinpoint the problem !!!