Hi, I've just put together an AM8 + IDEX, and am using a servo Z probe on T0.
G29 only probes a small area in the low X and high Y quadrant. I'm using bilinear levelling, and both hotend can travel from 0 to 185 in X.
X_PROBE_OFFSET_FROM_EXTRUDER is -19, so the probe can reach 0 to 166. To keep symmetry I'd expect it to probe the range 19 to 166, 147mm wide, and the 5 points should be (147/4) 36.75mm apart, but it looks to me like about half of that.
Does anyone know if this is likely to be a result of the dual X axis, or just a configuration error.
(I took my original config from my Anet A8 on which it worked a charm, just would save me a lot of sweat to know if I was wasting my time!)
Thanks,
Phil
G29 only probes a small area in the low X and high Y quadrant. I'm using bilinear levelling, and both hotend can travel from 0 to 185 in X.
X_PROBE_OFFSET_FROM_EXTRUDER is -19, so the probe can reach 0 to 166. To keep symmetry I'd expect it to probe the range 19 to 166, 147mm wide, and the 5 points should be (147/4) 36.75mm apart, but it looks to me like about half of that.
Does anyone know if this is likely to be a result of the dual X axis, or just a configuration error.
(I took my original config from my Anet A8 on which it worked a charm, just would save me a lot of sweat to know if I was wasting my time!)
Thanks,
Phil