Hello everyone
I am building a 3D Printer
every time I try to print, The extruder does not heating up "stays at room temperature" , while the heatbed heating up, but after 10 minutes an error appears
Using MK2A heated pcb bed (200x200)
when I turn on the bed and extruder from the software, the extruder reaches the temperature that i need, while the bed keep heating up until that the same error appears "after around 10 min"
I am building a 3D Printer
every time I try to print, The extruder does not heating up "stays at room temperature" , while the heatbed heating up, but after 10 minutes an error appears
Error:Heating failed, system stopped! Heater_ID: bed [ERROR] Error:Heating failed, system stopped! Heater_ID: bed Error: Printer halted. kill() called! [ERROR] Error: Printer halted. kill() called!
Using MK2A heated pcb bed (200x200)
when I turn on the bed and extruder from the software, the extruder reaches the temperature that i need, while the bed keep heating up until that the same error appears "after around 10 min"