Hi, I have a Tevo Tarantula, was using EasyConfig 1.0.X, so far so good.
Flashed the 2.0.X using Arduino 1.8.10.
The printer vibrates while printing curves. Tried the official Marlin BugFix 2.0.X version after optimize it to work on my printer.
Same thing happens, but it also slows down printing straight lines and it ends up with some "columns". I used the same Gcode for all my tests.
I played with jerk and acceleration.
Also flashed EasyConfig 2.0.x using older arduino versions and I'm having the same issue.
Inspected thoroughly the printer for broken brackets, lose screws, damaged belts, stepper motor current, etc.
Reflashed 1.0.X and it's working perfectly.
Jerk X/Y = 7
Acceleration = 800
Any idea??
Thanks.
Flashed the 2.0.X using Arduino 1.8.10.
The printer vibrates while printing curves. Tried the official Marlin BugFix 2.0.X version after optimize it to work on my printer.
Same thing happens, but it also slows down printing straight lines and it ends up with some "columns". I used the same Gcode for all my tests.
I played with jerk and acceleration.
Also flashed EasyConfig 2.0.x using older arduino versions and I'm having the same issue.
Inspected thoroughly the printer for broken brackets, lose screws, damaged belts, stepper motor current, etc.
Reflashed 1.0.X and it's working perfectly.
Jerk X/Y = 7
Acceleration = 800
Any idea??
Thanks.