X/Z axis proximity endstop help (no replies)

Hi guys,

I’ll explain the situation before my issue. At work we had a ormerod 1 with duet card, this had a proximity sensor for both Z and Y endstop position. It been in a box in bits and I was asked to look at it and get it going (it had been a few years ago I’m told).

Upon printing the first time the filament started to peel off the bed and getting stuck under the nozzle as it zipped back and forth, not wanting anything to be damaged- I yanked the plug from the wall and the board went pop!!

Now to where my issue comes,

I purchased a ramps 1.4 board with mega and started to transfer over all the wiring.
- Y endstop shows triggered and open when using m119 correctly and homes
- Z endstop shows triggered and open when using m119 correctly and homes to set height when probe is already over the bed
- X endstop does not work - as I’m trying to set it up the same as duet board, when moved to extreme left the sensor picks up the little bracket but still thinks this is z.

So, my question is how do I get the proximity to do both axis end stops on the ramps board as it did on the duet? There’s clearly some setting in the config I need to set.
Just to be clear the sensor is working (outputs a signal) just not working for x axis.
I’ll attach/insert pics of duet proximity wiring and the ramps, wired to z min - but need it to also function as x min.
[ibb.co]
[ibb.co]
[ibb.co]
[ibb.co]

[ibb.co]
[ibb.co]
[ibb.co]

Here is my configuration file too

So, the way I should see it working is, ramps homes Y first using the bracket to the side the moves in x amount over the board then z home.

Your help is greatly appreciated

Phil