I am currently having issues with my z-axis. I am unable to perform both a G28Z command and a G0Zxxx command. My steppers (two steppers for z with 8mm acme screws) just buzz briefly then stop.
It sounds like there is not enough current to drive them.
However, I am able to move the axis both up and down using the manual controls inside of a program such as pronterface or repetier.
This is a brand new build and I'm using an autoleveling probe. I'm not sure if any of that would be making this issue.
It sounds like there is not enough current to drive them.
However, I am able to move the axis both up and down using the manual controls inside of a program such as pronterface or repetier.
This is a brand new build and I'm using an autoleveling probe. I'm not sure if any of that would be making this issue.