I was makign some subtle changes on my print.. moving the Endstops form max to min, correcting the Stepper motor setting.. I had compiled it 3 times.. worked fine on print.
I when to recompile for a fourth time and I get an Error compiling for board RAMBo.
the last change I made was changing an endstop to -1 from 1
reset printer, computer restarted Arduino IDE.. still nothing but that error
I also have a Prusa Firmware printer, so I closed Marlin, opened the Prusa INO and want to try to just compile.. works fine
I saw the U8Glib.h errror, but it is onluy in one spot.. same with SPI as far as I can tell. I also deleted the temp folder arduino created with no luck
Tried to compile a couple other projects, they are just fine.. not sure what magically changed by going from 1 to -1
Attached is the log..
Thanks for any advice
Any suggestions?
I when to recompile for a fourth time and I get an Error compiling for board RAMBo.
the last change I made was changing an endstop to -1 from 1
reset printer, computer restarted Arduino IDE.. still nothing but that error
I also have a Prusa Firmware printer, so I closed Marlin, opened the Prusa INO and want to try to just compile.. works fine
I saw the U8Glib.h errror, but it is onluy in one spot.. same with SPI as far as I can tell. I also deleted the temp folder arduino created with no luck
Tried to compile a couple other projects, they are just fine.. not sure what magically changed by going from 1 to -1
Attached is the log..
Thanks for any advice
Any suggestions?