First layer is high on one side of the bed and low on the other after impleming auto bed leveling. Here's the matrix:
Bed 60C
SENDING:G29 V4
Bilinear Leveling Grid:
0 1 2 3 4
0 +0.002 +0.112 +0.197 +0.341 +0.506
1 -0.180 -0.068 +0.044 +0.174 +0.330
2 -0.260 -0.134 -0.013 +0.137 +0.251
3 -0.226 -0.088 +0.046 +0.142 +0.246
4 -0.066 +0.021 +0.063 +0.137 +0.244
Here's a link to the pic showing the uneven first layer. Shouldn't auto bed leveling handle such minor differences in bed height?
Bed 60C
SENDING:G29 V4
Bilinear Leveling Grid:
0 1 2 3 4
0 +0.002 +0.112 +0.197 +0.341 +0.506
1 -0.180 -0.068 +0.044 +0.174 +0.330
2 -0.260 -0.134 -0.013 +0.137 +0.251
3 -0.226 -0.088 +0.046 +0.142 +0.246
4 -0.066 +0.021 +0.063 +0.137 +0.244
Here's a link to the pic showing the uneven first layer. Shouldn't auto bed leveling handle such minor differences in bed height?