I've recently got ABL working with my Anet A8, and the prints are coming out great, but when I'm doing prints on pronterface I don't notice the z-axis height changing as it goes around the bed, shouldn't I see this value fluctuate by a couple hundredths if my bed is about that far out of alignment in any given spots? I thought maybe the value just doesn't update but I also don't see my z stepper motors moving as it prints across different parts of the bed. I've got G29 enabled on my starting g-code, is there something else I'm missing? If I can't observe any changes in the z-axis during the printing of a given layer, is it really bed-leveling at all? The prints are coming out good so surely something must be happening I imagine
↧