Octoprint bed heating kill called (no replies)

What is the problem?
Trying to print on my CR10v2 and SKR 1.4 Turbo. I have the bed temp set at 65, but it heats up to 55 and just stays there. Eventually I get this error: “Your printer’s firmware reported an error. Due to that OctoPrint will disconnect. Reported error: Heating failed, system stopped! Heater_ID: bed - Printer halted. kill() called!”

What did you already try to solve it?
I did a pid autotune and set the results Marlin and saved with an M500. I was able to start two prints…they failed but not because of the bed heating. Next time I tried a print, I got the error again.
These are essentially brand new heaters and thermistors. Thermistor connections are solid on both ends.

edit: I also replaced the existing bed thermistor with a brand new one. Same thing happened. I checked the connections mains to board and bed to board and they were both stout connections. Quit again at 55 degrees.

Logs
[attachment 115874 Configuration.h]
[attachment 115876 octoprint5.txt]
[attachment 115875 serial1.txt]

Additional information about your setup
OctoPi .17, OctoPrint 1.4, Raspberry Pi 3 B+, Creality CR-10 V2, SKR 1.4 Turbo with TMC 2208 drivers and a TFT35 v3 touch screen.

Thanks in advance for any help!

Pat