Let me explain; when printing, if I want to adjust the fan or turn it on/off or kill the print, it will not respond to that command immediately.
Often, I use emergency stop or hit reset for a simple kill. However, that leaves the head on the print for a time.
Obviously, some commands get thru immediately like emergency stop and bed/hotend temp changes,. Fan and kill commands would be good also.
Does anyone see this as an issue that should be addressed?
Often, I use emergency stop or hit reset for a simple kill. However, that leaves the head on the print for a time.
Obviously, some commands get thru immediately like emergency stop and bed/hotend temp changes,. Fan and kill commands would be good also.
Does anyone see this as an issue that should be addressed?