Hello- With this printer I seem to be solving one problem only to immediately find another (almost certainly because I do not fully understand the system) . i finally got everything sorted and carried out a few test prints ( 8 No, 30 x 30 x 10 boxes ) and satisfied myself that they were actually 30 x 30 x10, so far so good. I now recompiled the firmware to include the EEPROM settings not altering anything else, built and uploaded it with PlatformIO (the board is a 32bit SKR V1.3) but now it will home perfectly but when given any instruction to move away from home, be it manual control in Repetier or Pronterface or the LCD or a stl file put through Cura the hot end dives straight to the bed and is only stopped with the emergency stop button. i tried a new card and re-installed the firmware but no difference. I've never encountered anything like this before so am at a loss to know where to start looking for a solution, any help will be greatly appreciated.
↧