Dual X Carriage modes not working good (no replies)

FW Marlin: Bugfix 2.0.x
Downloaded: 27.6.2020 at 15:17 (Prague)

Dual X Carriage modes:
1. AUTO_PARK - OK
- the movement of the carriage X1 is limited between -47 and 240
- the movement of the carriage X2 is limited between 0 and 292
- tool change T0 and T1 is exact according to offset X

2. DUPLICATION - BUG 198 mm gap between carriers, X2 collided in endstop X Max
3. MIRRORED - BUG the carriages collide in the middle

Change the

 DEFAULT_DUPLICATION_X_OFFSET 

setting does not affect the gap between carriers.



Configuration:

#define DUAL_X_CARRIAGE
#if ENABLED(DUAL_X_CARRIAGE)
  #define X1_MIN_POS  X_MIN_POS    // -47 X-min endstop
  #define X1_MAX_POS  X_BED_SIZE   // 240    
  #define X2_MIN_POS    0           
  #define X2_MAX_POS    292        // 292 X-max endstop 	  
  #define X2_HOME_DIR   1     
  #define X2_HOME_POS X2_MAX_POS 

  #define DEFAULT_DUAL_X_CARRIAGE_MODE DXC_AUTO_PARK_MODE
  
  #define DEFAULT_DUPLICATION_X_OFFSET 120 
#endif

```