TOUCH_MI_PROBE (no replies)

I use Touch-MI Probe by hotends.fr
Is it possible to set a check that the probe is deploy ?

If the probe is not unlocked at G28, the HotBed hits the nozzle.

Configuration Z-probe:

#define TOUCH_MI_PROBE
#if ENABLED(TOUCH_MI_PROBE)
  #define TOUCH_MI_RETRACT_Z 1.0                  // Height at which the probe retracts
  #define TOUCH_MI_DEPLOY_XPOS (X_MAX_BED + 2)    // For a magnet on the right side of the bed
  //#define TOUCH_MI_MANUAL_DEPLOY                // For manual deploy (LCD menu)
#endif