Good Morning!
I have a 3D of my own construction and I use RAMPS 1.4 as a controller.
with marlin 1.1.x it is working well.
When I update FW to 2.0.6 I start having problems with auto leveling.
I send the command to level, he starts leveling and on the x-axis he starts not to make the correct movements as if he were missing steps and ends up going off the table.
And random time is correct and time is lost.
Returning to FW 1.1.4 it starts to work normally.
Another problem I have is the heating of the hotend I can't heat more than 220 degrees, someone can give me a hint how I can increase this limit.
TKS
I have a 3D of my own construction and I use RAMPS 1.4 as a controller.
with marlin 1.1.x it is working well.
When I update FW to 2.0.6 I start having problems with auto leveling.
I send the command to level, he starts leveling and on the x-axis he starts not to make the correct movements as if he were missing steps and ends up going off the table.
And random time is correct and time is lost.
Returning to FW 1.1.4 it starts to work normally.
Another problem I have is the heating of the hotend I can't heat more than 220 degrees, someone can give me a hint how I can increase this limit.
TKS