Hi,
I have a Folgertech i3 2020, running a ramps 1.4 and Marlin 1.0.2 firmware. I installed a inductive sensor for bed leveling and went through the setup on that and got the probing working fine. However, when it finishes probing it is at the back of the table and when the print starts, it tries to go off the table. It is like it lost its reference to the home position. I am doing a G28 before the G29 and then doing a m500 to store the values. I was told you shouldn't do a g28 after the probe or you will lose the values so I haven't tried that but I would think that since I am storing them I would be ok. So should I have to do a G28 again after the bed leveling or is something else maybe wrong?
Thanks Mark,
I have a Folgertech i3 2020, running a ramps 1.4 and Marlin 1.0.2 firmware. I installed a inductive sensor for bed leveling and went through the setup on that and got the probing working fine. However, when it finishes probing it is at the back of the table and when the print starts, it tries to go off the table. It is like it lost its reference to the home position. I am doing a G28 before the G29 and then doing a m500 to store the values. I was told you shouldn't do a g28 after the probe or you will lose the values so I haven't tried that but I would think that since I am storing them I would be ok. So should I have to do a G28 again after the bed leveling or is something else maybe wrong?
Thanks Mark,
