Hi. I installed Marlin from the GitHub Tronxy Tree on my TRONXY X5SA Pro 500. I uncomment the right printer in the firmware. I changed the number of Z-motors in the configuration.adv from 1 to 2 and all the motors move now. I changed the x (125) and y (125) home position because the printer was hitting the rear-right corner hardly. Homing works now near by the middle of the bed.
Strangely when I tell the printer to move 10mm in X or Y it actually moves 20mm . I did not change the steps/mm setting and in other forums people write the standard settings are right?
#elif WITH_TMC && WITH_TITAN
#define DEFAULT_AXIS_STEPS_PER_UNIT { 160, 160, 800, 764 }
What is the problem? Why does it move 20mm when I tell it to move 10mm?
Strangely when I tell the printer to move 10mm in X or Y it actually moves 20mm . I did not change the steps/mm setting and in other forums people write the standard settings are right?
#elif WITH_TMC && WITH_TITAN
#define DEFAULT_AXIS_STEPS_PER_UNIT { 160, 160, 800, 764 }
What is the problem? Why does it move 20mm when I tell it to move 10mm?