Hello everyone,
I have a delta printer running Marlin from about 5 years ago. I decided to configure current version of Marlin 2.0 for this printer. The goal is to mitigate inconsitstent ABL where the middle of printbed is great but to the edge it gets much worse.
My problem is that I am using allen key probe so for deploying and stowing I need to go outside the print area and Marlin prevents that. A workaround is to increase the printable radius but that would enable the printhead to crash into one of the towers.
Is there some setting that would allow going out of print area only for deploying and stowing the probe?
The original method was hardcoded to the firmware (in Marlin_main.cpp) I presume to overcome this limitation.
I am attaching the configuration files I am trying to use.
Thank you in advance
I have a delta printer running Marlin from about 5 years ago. I decided to configure current version of Marlin 2.0 for this printer. The goal is to mitigate inconsitstent ABL where the middle of printbed is great but to the edge it gets much worse.
My problem is that I am using allen key probe so for deploying and stowing I need to go outside the print area and Marlin prevents that. A workaround is to increase the printable radius but that would enable the printhead to crash into one of the towers.
Is there some setting that would allow going out of print area only for deploying and stowing the probe?
The original method was hardcoded to the firmware (in Marlin_main.cpp) I presume to overcome this limitation.
I am attaching the configuration files I am trying to use.
Thank you in advance