Good afternoon, im building a system with marlin firmware and i want to connect more than 4 servos.
The board i have is the MKS GEN L V1.0 wich has RAMPS 1.4 built in, this one has 4 connectors for servo and they work properly.
The question is that the 4 extra servos that i want to connect, my idea was to take other digital pins from the auxiliary sectors that mks gen has and rename them to servos.
I rename them through the pins files and configuration.h file i put max 8 servos.
I had to remove security from "sanitycheck.h" because if not, it wouldnt me compile it says this board doesnt support that number of servos but i had other digital pins built in pcb. But the case that when i connect the fifth servo through pronterface it let me send the command M280 PP5 S90 but the servo does absolutely nothing.
Some help?
Thanks!
The board i have is the MKS GEN L V1.0 wich has RAMPS 1.4 built in, this one has 4 connectors for servo and they work properly.
The question is that the 4 extra servos that i want to connect, my idea was to take other digital pins from the auxiliary sectors that mks gen has and rename them to servos.
I rename them through the pins files and configuration.h file i put max 8 servos.
I had to remove security from "sanitycheck.h" because if not, it wouldnt me compile it says this board doesnt support that number of servos but i had other digital pins built in pcb. But the case that when i connect the fifth servo through pronterface it let me send the command M280 PP5 S90 but the servo does absolutely nothing.
Some help?
Thanks!