Hey, I upgraded my cr10 with an SKR 1.3V board running Marlin bugfix 2.0.x
But it's crashing the X and Y every time I start a print I set the bed size to 300mm as seen in the image but soon as the printer Is done homing it will just take off and crash It acts as the print bed is bigger then it is but I don't know what to do so if you have any suggestions it would be greatly appreciated
But it's crashing the X and Y every time I start a print I set the bed size to 300mm as seen in the image but soon as the printer Is done homing it will just take off and crash It acts as the print bed is bigger then it is but I don't know what to do so if you have any suggestions it would be greatly appreciated