Dear community,
I built my own 3D printer.
The limit switch for X is on the right side of the printer, i.e. Endstop_Max. The stepper is also installed on the right.
The limit switch for Y is in front, so Endstopp_Max and the stepper too.
The limit switch for Z is down and would be endstop_min.
My problem now is that I can't figure out how to set this in Marlin. I've tried several things, but no useful result. In addition, the printer only moves small steps during auto homing.
Please help.
Thanks in advance.
I built my own 3D printer.
The limit switch for X is on the right side of the printer, i.e. Endstop_Max. The stepper is also installed on the right.
The limit switch for Y is in front, so Endstopp_Max and the stepper too.
The limit switch for Z is down and would be endstop_min.
My problem now is that I can't figure out how to set this in Marlin. I've tried several things, but no useful result. In addition, the printer only moves small steps during auto homing.
Please help.
Thanks in advance.