Quantcast
Channel: Reprap Forum - Firmware - Marlin
Viewing all articles
Browse latest Browse all 2838

Issues with y direction in corexy (1 reply)

$
0
0
Hey guys,

I have been struggling with getting my corexy printer running on a ramps board with marlin installed. The old controller was a closed source one from chitu3d but even after triple checking the config Im quite sure that I copied all the mechanical settings. So Im having an issue with the y-axis moves in the wrong direction.it moves towards the origin when y is positive and no matter how much I switch the motor cables around or change it to #define coreyx or invert the y axis direction(which yields the same results somehow) it still moves and homes in the opposite direction. I tried setting homing direction to -1 but it jerked for a few cm and show maximum readings for the axes. To my knowledge the original config file for the printer did not invert any axis either. Any help would be greatly appreciated. Thanks

Link to my configuration file

Viewing all articles
Browse latest Browse all 2838


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>