This is a new posting of a problem that I started by saying Help Needed. I have worked this down to where a gentleman by the nave of Dust has been helping me. He asked for a video of my problem of which I never have done. I recorded a 33 sec video but it was to large for me to transfer to email. So now I have a 11 second video that I was able to create in a YouTube short viewing. I am trying to make sure the gentleman gets this so here goes .
The address of the video is (https://youtube.com/shorts/bD-WvoQPGAc). I hope it works. Dust has told me the configuration files are OK so I am not attaching them.
I am wondering if the Arduino 260 board is ok as the operation of the bltouch is fine as long as the USB cable is connected to the printer. Unplug the USB and printer functions, but when you try to home y axis the bltouch begins to flash and light is flashing, power supply seems to load up, and screen turns to blue and is fluttering in the background. The only thing you can do is turn it off.
The address of the video is (https://youtube.com/shorts/bD-WvoQPGAc). I hope it works. Dust has told me the configuration files are OK so I am not attaching them.
I am wondering if the Arduino 260 board is ok as the operation of the bltouch is fine as long as the USB cable is connected to the printer. Unplug the USB and printer functions, but when you try to home y axis the bltouch begins to flash and light is flashing, power supply seems to load up, and screen turns to blue and is fluttering in the background. The only thing you can do is turn it off.