Hi all,
i have an issue with my 3D printer, an Ender 3v2 with the CR probe installed. I have installed this firmware GD-Ender-3 V2-Marlin2.0.8.2-HW-V4.2.2-SW-V1.0.7_E_N_BLTouch. I removed the z-switch, added the G29 code in the gcode, done the z-offset and the bed leveling, stored the configuration values, but when i print there isn't the compensation and don't adjust the Z-axis during printing of the various layers. Have any solution?
i have an issue with my 3D printer, an Ender 3v2 with the CR probe installed. I have installed this firmware GD-Ender-3 V2-Marlin2.0.8.2-HW-V4.2.2-SW-V1.0.7_E_N_BLTouch. I removed the z-switch, added the G29 code in the gcode, done the z-offset and the bed leveling, stored the configuration values, but when i print there isn't the compensation and don't adjust the Z-axis during printing of the various layers. Have any solution?