Hello all
My first post here :-) so hello again.
I have a strange problem with Marlin 2.1.2.2 on the smoothieboard 1.0b.
The Full graphpic smart controller display does not show any fan icons.
Both fans (extruder/controller) are set as auto fans and work as they should.
The prints looks good too.
I have tried various things and also played a bit with the fan.h and dogm_statusscreen.h but without success.
Then I downloaded Marlin again and created the config again with the same result.
No fans.
Google brings no results so I think it is a rather rare phenomenon.
Next I will try the bugfix branch
Maybe someone have a idea what i could try also ?
Thanks in advance.
Cheers Joerg
My first post here :-) so hello again.
I have a strange problem with Marlin 2.1.2.2 on the smoothieboard 1.0b.
The Full graphpic smart controller display does not show any fan icons.
Both fans (extruder/controller) are set as auto fans and work as they should.
The prints looks good too.
I have tried various things and also played a bit with the fan.h and dogm_statusscreen.h but without success.
Then I downloaded Marlin again and created the config again with the same result.
No fans.
Google brings no results so I think it is a rather rare phenomenon.
Next I will try the bugfix branch
Maybe someone have a idea what i could try also ?
Thanks in advance.
Cheers Joerg