I am making an idex 3d printer and using Marlin 2.1.x firmware. I have compiled the firmware successfully but when I home the axis, the X2 motor doesn't home. In fact, when I press the homing button, first the X1 homes successfully and then printer goes straight for the bed homing and instead of X2 homing.
The board I am using is MKS monter8 V2.
I have enabled the all the settings required for an idex printer like; number of extruder, dual X carriage, etc., and also attaching the screenshots and configuration.h and configuration_adv files.
has anybody of you experienced the same problem ?
The board I am using is MKS monter8 V2.
I have enabled the all the settings required for an idex printer like; number of extruder, dual X carriage, etc., and also attaching the screenshots and configuration.h and configuration_adv files.
has anybody of you experienced the same problem ?