Marlin 1.1.4 UBL issue (no replies)

Hello, im trying to configure UBL on my Sunhokey I3 with capacitive probe connected to z- min endstop
G28 works as expected.
I have 3X3 mesh set in FW.
I'm following [marlinfw.org] for setup.
The first phase 'G29 P1' ends up with the following points probed (X- probed/Y-not probed):
YYY
XXX
XXX

all offsets reported by 'G29 T' are between 0.7 and -1.2
The second phase 'G29 P2' (manual) my offsets are huge -3.1 and -1.7
Now, when i try to print test patter with G26, the manual points are printed OK but the auto-probed point are far away from the bed, in the air (about 3-4 mm from the bed).

Does anyone have a clue why auto probed points printed in the air?

Recv: (0,2)           (2,2)
Recv: (15,183)        (185,183)
Recv:  -3.150   -2.330  [-1.710]
Recv: 
Recv:  -0.699    0.136    0.759
Recv: 
Recv:  -1.229   -0.399    0.291
Recv: (15,15)            (185,15)
Recv: (0,0)             (2,0)

If i try to fine tune the auto-probed point with 'G29 P4 T' , i get huge offsets that do not make any sence . its like there is some sort of offset applied :
im bellow map , i manually tuned the bottom left auto-probed point

Recv: (0,2)           (2,2)
Recv: (15,183)        (185,183)
Recv:  -3.150   -2.330   -1.710
Recv: 
Recv:  -0.699    0.136    0.759
Recv: 
Recv: [-7.080]  -0.399    0.291
Recv: (15,15)            (185,15)
Recv: (0,0)             (2,0)