My probe I installed is far away from the nozzle (offset -x45 y17), maybe my endstop z or hotbed is not level, the result is useless.
My question is how to level the endstops? is G33 my solution?
if so, what's the different between G33 and G29? the document says it can auto calibration endstops, tower angles and so on, can i use it even if the hotbed is not level? what's G33's principle?
thx!
My question is how to level the endstops? is G33 my solution?
if so, what's the different between G33 and G29? the document says it can auto calibration endstops, tower angles and so on, can i use it even if the hotbed is not level? what's G33's principle?
thx!