Thermistor selection (no replies)

I have a SEMITEC 104NT-4-R025H42G screw in type thermistor on my hotend.

I dont see that on the thermistor table to select so I used type 5 104GT-2 with Marlin 1.18

Googleing about a bit I am pretty sure they dont have the same curve.

I was wondering if there is a way to use the Steinhart Hart algorythm to input the curve as I have found all that data:

104NT-4R025H42G

I for Steinhart Hart 0.000797110609710217F
J for Steinhart Hart 0.000213433144381270F
K for Steinhart Hart 6.5338987554e-08F

Thanx in advance :)