Happy New Year!
I've been banging my head against the wall trying to get my BLTouch setup. This is what the terminal on Octoprint outputs when I start up:
I'm able to restart the serial connection and run Gcode commands. The following commands run as they should:
Attached is my configuration file. Any help on eliminating the errors would be greatly appreciated.
Thank you very much.
Loren
I've been banging my head against the wall trying to get my BLTouch setup. This is what the terminal on Octoprint outputs when I start up:
Quote
Recv: Error:STOP called because of BLTouch error - restart with M999
Changing monitoring state from 'Connecting' to 'Error: STOP called because of BLTouch error - restart with M999
'
Recv: Error:Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
Recv: ok
Changing monitoring state from 'Error: STOP called because of BLTouch error - restart with M999
' to 'Offline'
I'm able to restart the serial connection and run Gcode commands. The following commands run as they should:
Quote
M280 P0 S10 ; pushes the pin down
M280 P0 S90 ; pulls the pin up
M280 P0 S120 ; Self test – keeps going until you do pin up/down or release alarm
M280 P0 S160 ; Release alarm
Attached is my configuration file. Any help on eliminating the errors would be greatly appreciated.
Thank you very much.
Loren