Hi guys,
I've just built a corexy machine from scratch and am in the process of doing the electronics.
I started off with an arduino mega and ramps board running marlin 1. And all went well for testing up until i tried to use the bi linear mesh bed levelling. I'm sure it's a case of the mega just not being powerful enough to do the corexy kinematics as well as the mesh bed compensation.
So I purchased a re-arm thinking it would be a plug n drop replacement, but i'm stumped on setting it up so far.
does anyone know of a tutorials/instructions anywhere I could follow to set it up? I cant seem to find any :(
I read that it doesnt work with the letter type displays (the non graphic ones). is this true or has the compatibility now been added?
Many thanks in advance
I've just built a corexy machine from scratch and am in the process of doing the electronics.
I started off with an arduino mega and ramps board running marlin 1. And all went well for testing up until i tried to use the bi linear mesh bed levelling. I'm sure it's a case of the mega just not being powerful enough to do the corexy kinematics as well as the mesh bed compensation.
So I purchased a re-arm thinking it would be a plug n drop replacement, but i'm stumped on setting it up so far.
does anyone know of a tutorials/instructions anywhere I could follow to set it up? I cant seem to find any :(
I read that it doesnt work with the letter type displays (the non graphic ones). is this true or has the compatibility now been added?
Many thanks in advance