I'm about to move to 1.1.8 from 1.1.4 and I'm going to give UBL a shot but I'm curious: do the mesh adjustments apply during normal moves, or only during prints?
For example - what if based on my mesh that X50 Y50 needed a Z compensation of -0.05
If I manually sent G1 X50 Y50 F2400 then G1 Z0 F1200 would my nozzle actually end up at a true Z0 (so, compensated) or would it be at +0.05 (no compensation)?
For example - what if based on my mesh that X50 Y50 needed a Z compensation of -0.05
If I manually sent G1 X50 Y50 F2400 then G1 Z0 F1200 would my nozzle actually end up at a true Z0 (so, compensated) or would it be at +0.05 (no compensation)?