After uploading marlin 1.1.8 to my I3 printer and autobed levelling was already enabled Z axis switch doesn't work. I tested with M119 code and it say z_min: open
when I press z switch it say z_min triggered.
X and Y works OK.
I also noticed when I press Z home in repetier, on LCD shows this G28 Z forbidden
Can't find what can be wrong.
when I press z switch it say z_min triggered.
X and Y works OK.
I also noticed when I press Z home in repetier, on LCD shows this G28 Z forbidden
Can't find what can be wrong.