Hi There,
The XY endstops on my i3 type printer is 10 to 12mm outside the printing area. It is fine for X and Y homing but not for the Z Probe which does not sense the buildplate. Is it possible, for example, to move the X axis immediately back 10mm from the endstop after it homed and say that position is X0? The same is true for Y.
I use an Arduino 2560 board with a Ramps1.4 shield and Marlin 010107 firmware.
Thank you
The XY endstops on my i3 type printer is 10 to 12mm outside the printing area. It is fine for X and Y homing but not for the Z Probe which does not sense the buildplate. Is it possible, for example, to move the X axis immediately back 10mm from the endstop after it homed and say that position is X0? The same is true for Y.
I use an Arduino 2560 board with a Ramps1.4 shield and Marlin 010107 firmware.
Thank you