I have a cr-10s and would like to add 4 more points to my mesh bed leveling pattern.
However, I do not want to add them to the outside line but rather in select midpoints between the outer edge and center (see attached).
I know were to add the number of points per axis, but not where to set the positions for them.
Is this possible?
![mesh_points.jpg]( "mesh_points.jpg")
However, I do not want to add them to the outside line but rather in select midpoints between the outer edge and center (see attached).
I know were to add the number of points per axis, but not where to set the positions for them.
Is this possible?
