This is my first time trying Marlin. I have uploaded the firmware to my board but when I try to connect to my printer in Pronterface it just stalls on connecting.
However everything appears to load properly on the lcd. I can use it to go in and move the axis, shows the bed and hotend temps etc.
I would like to use Marlin over sprinter as I really want to make use of the lcd and sd slot.
Any help would be much appreciated.
Hardware I'm using is:
Mega-2560
RAMPS 1.4 Controller
A4988 Stepper Driver
RepRapDiscount Smart Controller LCD
However everything appears to load properly on the lcd. I can use it to go in and move the axis, shows the bed and hotend temps etc.
I would like to use Marlin over sprinter as I really want to make use of the lcd and sd slot.
Any help would be much appreciated.
Hardware I'm using is:
Mega-2560
RAMPS 1.4 Controller
A4988 Stepper Driver
RepRapDiscount Smart Controller LCD