Hi,
I upgraded to Marlin 1.1.9 and finally configured my cap sensor for abl. I have read trough numerous posts without luck.
When i put in the probe z offset either trough octoprint Marlin eeprom plugin or cr-10 control box (in my case -0.3) the value saves to eeprom,
but the only thing that changes is the Z value on the lcd. If i put in -0.3 the lcd Z value shows +0.3 after g28. M851 reports Z -0.3. Z does not move closer to bed with respect to the offset.
Any idea what im doing wrong? My marlin 1.1.9 config.h is attached
Thanx
I upgraded to Marlin 1.1.9 and finally configured my cap sensor for abl. I have read trough numerous posts without luck.
When i put in the probe z offset either trough octoprint Marlin eeprom plugin or cr-10 control box (in my case -0.3) the value saves to eeprom,
but the only thing that changes is the Z value on the lcd. If i put in -0.3 the lcd Z value shows +0.3 after g28. M851 reports Z -0.3. Z does not move closer to bed with respect to the offset.
Any idea what im doing wrong? My marlin 1.1.9 config.h is attached
Thanx