Hi
I got one DaVinci 1.0 converted now with mks board and e3dv6 with direct extruder but pancake motor that hotend carriage didn't have enough torque so i mount stock davinci motors for direct extruder.
and now after homing X and Y on x y max if moves straight to center of the bed and now motor hits some of the printer parts so i need to add a behavior so before ech Z homing and before each prints first carriage need to go in Y -20 mm and then to desired position how and where can i change this in Marlin source code ?
thx for any help I just don't want to disassemble it again and put some new carriage.
I got one DaVinci 1.0 converted now with mks board and e3dv6 with direct extruder but pancake motor that hotend carriage didn't have enough torque so i mount stock davinci motors for direct extruder.
and now after homing X and Y on x y max if moves straight to center of the bed and now motor hits some of the printer parts so i need to add a behavior so before ech Z homing and before each prints first carriage need to go in Y -20 mm and then to desired position how and where can i change this in Marlin source code ?
thx for any help I just don't want to disassemble it again and put some new carriage.