After dealing with an inductive Z probe that returned imprecise results I switched to manual bed leveling on my Printrbot Simple Metal and removed the errant sensor.
I'm worried that if I accidentally click the home-Z button that the printer will crash the hotend into the build plate. I'm loath to leave the sensor plugged in with foil wrapped around the end, as it just seems like a poor solution. Is there a way to disable this sensor/gcode in Marlin without recompiling?
I'm worried that if I accidentally click the home-Z button that the printer will crash the hotend into the build plate. I'm loath to leave the sensor plugged in with foil wrapped around the end, as it just seems like a poor solution. Is there a way to disable this sensor/gcode in Marlin without recompiling?