M122 returns wrong driver information (1 reply)

Hi,

I´m using Marlin 1.1.9 on a ramps 1.4 with 5 TMC2208 drivers (connected with serial Y cable). E1 is used as Z1 for the second Z stepper. Basically everything works fine, but it seems that M122 returns the wrong stepper information (Z2 instead Z1):

06:44:32.146 : X Y Z Z2 E0
06:44:32.182 : Enabled false false false false true
06:44:32.187 : Set current 350 350 200 100 350
06:44:32.219 : RMS current 607 607 331 165 607
06:44:32.252 : MAX current 856 856 467 233 856
06:44:32.252 : Run current 10/31 10/31 5/31 2/31 10/31
06:44:32.256 : Hold current 5/31 5/31 2/31 1/31 5/31
06:44:32.289 : CS actual 31/31 31/31 31/31 0/31 0/31
06:44:32.316 : PWM scale 146 148 136 0 36
06:44:32.350 : vsense 0=.325 0=.325 0=.325 0=.325 0=.325
06:44:32.383 : stealthChop true true true false false
06:44:32.412 : msteps 16 16 16 256 16

Is this really a bug or do I miss something?

Best regards