Ok so i updated from Marlin 1.0.1 to 1.1.9
Problems so far
1. Axis all seem inverted when i move them manually
2. When i home X it go the right direction for like 1mm then drops z like 5mm
3. My bed temp sensor seems to think its in the pits of hell as it reads it could melt steel!
any idea what i hosed up here ?
Problems so far
1. Axis all seem inverted when i move them manually
2. When i home X it go the right direction for like 1mm then drops z like 5mm
3. My bed temp sensor seems to think its in the pits of hell as it reads it could melt steel!
any idea what i hosed up here ?