I recently upgraded all three axes of my 2020, added a 3D touch, and uploaded 1.1.9, then tried 1.1.9 bugfix from 01/18/2019. I use RAMPS 1.4, and OCTOPI on a Rasbpi 3.
The printer homes, heats and otherwise appears normal.Using the LCD panel I can move all 3 axes and the extruder, distances are good and the bed levelling seems fine.
Using the terminal any G code Y move the printer will move X to the zero and Y will move to an incorrect location. Any G code X move the Y will move to max and keep trying to go for a while, and afterward the X will move to an incorrect position. Gcode Z moves produce similar results.
Printing from octoprint or SD card printing also send the printhead off into the wilderness.
The printhead is always out of bounds after this happens. I suspect there is an error in my configuration files, I have thoroughly checked all of the electrical connection and drivers, etc.
For sanity, my CR10 is fine.
Any help greatly appreciated.
The printer homes, heats and otherwise appears normal.Using the LCD panel I can move all 3 axes and the extruder, distances are good and the bed levelling seems fine.
Using the terminal any G code Y move the printer will move X to the zero and Y will move to an incorrect location. Any G code X move the Y will move to max and keep trying to go for a while, and afterward the X will move to an incorrect position. Gcode Z moves produce similar results.
Printing from octoprint or SD card printing also send the printhead off into the wilderness.
The printhead is always out of bounds after this happens. I suspect there is an error in my configuration files, I have thoroughly checked all of the electrical connection and drivers, etc.
For sanity, my CR10 is fine.
Any help greatly appreciated.