BLTOUCH + DUAL Z ENDSTOPS (no replies)

Hello!
I am already using dual Z motors with seperate drivers and individual Z endstops for my Tronxy X5S.
One Z endstop connected to Zmin and the other to Zmax. Also I have enabled manual mesh leveling. All good!


I want to add BLtouch ONLY FOR AUTO LEVELLING and not for Z homing.
IMO this type of machine must have individual Z endstops to have the bed level and so I did.

The bltouch will connect to the Xmax or Ymax.
So. here is the help I need. How can I configure the code to use the bltouch only for auto levelling and use the dual Z endstops for homing?


I searched a lot but no luck...

Thanks!

Giorgos