Hi...
I have a Flsin plus i3 which is about to go flying out a window...
Couldn't get auto Level to work so I thought id go back to a micro switch, simple... no.
Every time I home the Z-axis it lifts up, which is fine, but then when it goes to print it will not drop to the right height so i end up printing 2mm in the air. when homing the nozzle is the correct height when the switch is activated so its not that part.
i went into the Marlin code and turned off all i could find that lifts the Z after homing, just to see and still no luck.
Then i thought it was my slicer, Simplify 3d but none of the gcode there says to do a lift. (bear in mind i run 2 ultimakers and another kit printer too)
Ive just about had it with this thing. Can anyone lend a hand?
I have a Flsin plus i3 which is about to go flying out a window...
Couldn't get auto Level to work so I thought id go back to a micro switch, simple... no.
Every time I home the Z-axis it lifts up, which is fine, but then when it goes to print it will not drop to the right height so i end up printing 2mm in the air. when homing the nozzle is the correct height when the switch is activated so its not that part.
i went into the Marlin code and turned off all i could find that lifts the Z after homing, just to see and still no luck.
Then i thought it was my slicer, Simplify 3d but none of the gcode there says to do a lift. (bear in mind i run 2 ultimakers and another kit printer too)
Ive just about had it with this thing. Can anyone lend a hand?