I installed example configuration for Ender 3 so i can install BLTouch to printer.
Only one issue so far I've come across
The line below (as of current version)
127 //#define BLTOUCH,
//if ENABLED(BLTOUCH) , does not exist in the patches for 1.1.9 bugfix-1.1.x, just 2 empty lines then a load of following grayed out text,
" * Enable one or more of the following if probing seems unreliable.
* Heaters and/or fans can be disabled during probing to minimize electrical
* noise. A delay can also be added to allow noise and vibration to settle.
* These options are most useful for the BLTouch probe, but may also improve
* readings with inductive probes and piezo sensors."
Below this just a choice of probe settings, shut off heaters etc. Is this an error or am i missing something?
Thanks.
Only one issue so far I've come across
The line below (as of current version)
127 //#define BLTOUCH,
//if ENABLED(BLTOUCH) , does not exist in the patches for 1.1.9 bugfix-1.1.x, just 2 empty lines then a load of following grayed out text,
" * Enable one or more of the following if probing seems unreliable.
* Heaters and/or fans can be disabled during probing to minimize electrical
* noise. A delay can also be added to allow noise and vibration to settle.
* These options are most useful for the BLTouch probe, but may also improve
* readings with inductive probes and piezo sensors."
Below this just a choice of probe settings, shut off heaters etc. Is this an error or am i missing something?
Thanks.