Hi all, so several weeks back I successfully built Marlin firmware when I installed MakerbaseTMC 2209 v2 drivers on my Tevo Tornado and everything was working fine.
Well a few days I decided to use the latest Firmware, now I am seeing errors.
Using gcode M122, I see:
Recv: Testing X connection... Error: All LOW
Recv: Testing Y connection... Error: All LOW
Recv: Testing Z connection... Error: All LOW
Recv: Testing E connection... Error: All LOW
I haven't changed anything on my printer, I've checked my file diff several times with my Configuration files and I don't see anything off. I've re-watched the YouTube setup video by Makerbase to make sure I didn't fat finger anything.
Has anyone reported the same? Can anyone help.
Here is my configuration file: [github.com]
The motherboard I am using is MSK Gen L V1.0
TMC2209 Driver v2.0 made by Makerbase
Well a few days I decided to use the latest Firmware, now I am seeing errors.
Using gcode M122, I see:
Recv: Testing X connection... Error: All LOW
Recv: Testing Y connection... Error: All LOW
Recv: Testing Z connection... Error: All LOW
Recv: Testing E connection... Error: All LOW
I haven't changed anything on my printer, I've checked my file diff several times with my Configuration files and I don't see anything off. I've re-watched the YouTube setup video by Makerbase to make sure I didn't fat finger anything.
Has anyone reported the same? Can anyone help.
Here is my configuration file: [github.com]
The motherboard I am using is MSK Gen L V1.0
TMC2209 Driver v2.0 made by Makerbase