Hello everyone,
This is my first message on here.
I am repairing a Rep Rap printer from 2013. I have attached a few pictures of it.
I know quite a bit about hotend endstops and other "mechanical" parts of printers, but when it comes to software I am a complete nobe.
I needed to add new endstops, an LCD display, more fans and a new hotend, which meant changing the software.
I downloaded the latest version of Marlin and worked on it litteraly nights, but it does not compile at all and gives me the error #if without #endif.
There are also some parts of the code that I am not really sure about, like the accelleration or the correct calibration of the theremistors.
This made me think if I could just change some things in the old software of the printer so that I do not have to set it up completely new.
So is there a way to extract the software from the printer right now and change a few things in it?
I do not know what to do.
Please let me know.
By Paul
This is my first message on here.
I am repairing a Rep Rap printer from 2013. I have attached a few pictures of it.
I know quite a bit about hotend endstops and other "mechanical" parts of printers, but when it comes to software I am a complete nobe.
I needed to add new endstops, an LCD display, more fans and a new hotend, which meant changing the software.
I downloaded the latest version of Marlin and worked on it litteraly nights, but it does not compile at all and gives me the error #if without #endif.
There are also some parts of the code that I am not really sure about, like the accelleration or the correct calibration of the theremistors.
This made me think if I could just change some things in the old software of the printer so that I do not have to set it up completely new.
So is there a way to extract the software from the printer right now and change a few things in it?
I do not know what to do.
Please let me know.
By Paul